Instructions : Nano4-Plastic Cars & Bikes

Before you apply, make sure the surface is clean, dry and free of residues.
Do not dilute Nano4-Plastic with water as it is not required.
Once the surface is clean and dry, apply Nano4-Preclean product by spraying 15cm away (on a small area 30cm X 30cm at a time) and rub the surface with a micro fibre cloth in a circular motion. Nano4-Preclean is used to remove any previous chemical residues to ensure the glossy surface is clean.
Now apply Nano4-Plastic by spraying 15cm away (on a small area 30cm X 30cm at a time) and rub on the target surface with a new micro fibre cloth in a circular motion. Once sprayed, make sure you wipe it straight away and don’t let it dry up. Give it a good polish and continue until complete.
Nano4-Plastic takes about 12-24 hours (occurs under ambient conditions) to be fully cured. In case of higher atmospheric humidity longer curing times are necessary.
Protection last up to 5 years for new stainless steel surfaces provided application is made in accordance to instructions. However, you may need to re-apply earlier for optimum result.

100ml and 200ml. For bottles larger than 200ml please contact us directly.

One litre can cover up to 200m² where the application is made by using a HVLP spray gun.

Always apply in a well ventilated area
Apply when surface temperature is between 5-30°C
Do not let products dry up before polishing
Avoid moisture contact with the surface after application until fully cured for 24 hours for optimum results
Wear gloves and protective clothing
Avoid applying in windy conditions
Wash hands after application
Highly flammable
Keep ignition sources away - Do not smoke
Keep out of reach of children
PH Value 14 or above cleaner can destroy the effect
Nano4-Plastic does not protect against acid, etching, wear and high water pressure 50 bar and above